Для студии и концертов
ETEK Dynamagic 2 channel compressorThe explanation of goods: From an acquaintance, Im commissioned, and, its exhibition. Exhibition only of the Dynamagic body and the power cord which come out in a picture. Movement could be used with no problem in particular. There are no instruction manuals, but I think if the word which comes out was the one used including competitors products almost so, the contents shown to the body can use every compressor with no problem. I have 2 channels and its possible to change setting at HIGH and LOW respectively (The band HIGH/LOW takes charge of by a control of "X-OVER FREQ" is changed. )"AVG" and an indicated place are setting of an attack and release (Its possible to change only the change in SLOW and FAST in HIGH/each LOW. ) by a front panel. Notice: It could be used with no problem in particular. The lighting up of a level meter and the lighting up of a lamp by a MODE change (The color changes with a change in "IN/BYPASS". ) are no problem. There seems to be a time lag a little after a change in AVG presses a button. When sound is input to the time of power supply off, the condition (as the time done in the state of BYPASS) tone of moto is being output. Input/output is XLR or a TRS phone connection both. There is coming off of a scar and a painting film around the screw hole because the state of the body fixed the state of the body on a rack and used it. There is grazing of a line scar (The reflective condition of the light sees and doesnt see. ), a line bruise and a printout in the heaven board side of the front panel and the drawer bottom side. It isnt the deep bruise which is to the extent a bump is made. There is breaking of the scar by grazing and the painting film in an iron plate part of drawer bottom, upper end of a front panel and the bottom tip part a little. It doesnt feel like that I have chosen as rubbing against contact with other machinery and materials at installation to a rack and removal (It was said that they went several times. ) and have died, so I think there are no problems in particular. There is grazing in a film part for power cord. Power plugs are 3 cores originally, an earth pin is removed and a connection has been in the possible state in a general outlet. There is no breaking, so the position which can be used with no problem in particular can be kept.
Купить бу акустическую систему, комбик, микшерный пульт в Балашихе. Доска объявлений Балашихи, найдите свежие частные объявления с фото и ценой на сайте Sobut.ru или авито.